-
-
MI use short-circuited socket on the MMCX side (to measure all the jack - socket - jack path) and UNI-T UT117C in Rel mode on the jack side.
-
Mmetrics replied to the thread Earbuds Round-Up.As we are talking about cables, how do you measure cable impedance?
-
MOh Noooooo!!! Say it ain't so! So far my experience showed no difference - I decided to not be a "cable believer". Your assessment makes...
-
MYes, I did. Should I have posted this in the DIY earbuds thread?
-
MPersonally (and I hope others agree) I think this is the perfect place here. Love to see everybody's creations! After all this is the...
-
MIt was my understanding that cable resistance matters a lot. So if you are using a 16 Ohm earbud with a cable with a low resistance of...
-
MYes, you are absolutely right, the calf is a torment - whatever I tried it never sounded right to me! 😁 Regarding the RY4S - I usually...
-
MOur emotions are stronger than both our mind and reality (whatever they are). That's why "I just like it" almost always wins, and that's...
-
MI totally agree with every word you say. Let me add, that I do believe in magic, and not because I have any proof or am sceptic about...
-
Mmetrics replied to the thread Earbuds Round-Up.Apologies for response delay, postponing stuff is a vice. Hmm, nice thinking, an angled connector must solve it. I think i'm going for...
-
MA few weeks ago there were some posts about people's daily drivers that I meant to make a post about but wasn't feeling well at the...
-
MWell my honeymoon phase with the DB1E came to an abrupt and unfortunate end yesterday. I was hoping to avoid some of the issues that...
-
Mmt877 wrote his impressions here and also quoted omerad's impressions here. Those are the two most detailed impressions I've seen for...
-
MI'm curious what you think about RY4S 300 ohm buds
-
MWill let everyone know when I had some time with them.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…